RF4:- Settings for Transformer Over Current Relay

OcEf Calc Grid Line
     As shown in the figure consider a   transformers;  Transformer capacity is  MVA.  HV CTR is /1 Amp  and it's LV CTR is /1 Amp.  132kV Bus Three Phase short circuit MVA is  MVA  and transformer percentage reactance is  %.  Transformer has 17 taps and normal tap is 

     Information of provision of alarm and Load Trimming Scheme is as below 
     ALARM =  
     LTS =  

     Calculate HV Side and LV Side Over Current relay settings for the transformer.

(NOTE: While calculating HV side O/C PSM for under loaded T/F it is not necessary to consider T/F HV side current on extreme tap. For fully loaded T/F HV side PSM shall be as per current on extreme tap; it shall be 5% more along with Alarm scheme and 10% along with LTS)
Section-A: Calculations for Fault Current and PSM.
1) Source reactance at 100 MVA base =    %
2) T/F % impedance at 100 MVA base =    %
3) LV Bus Source reactance at base 100 MVA =    %
4) LV Bus Short Circuit MVA =    MVA
5) T/F LV Short Circuit Current =    Amp.
6) T/F HV Short Circuit Current =    Amp.
7) Transformer LV side O/C Relay PSM =    %.
8) Transformer HV Side O/C Relay PSM =    %.
9a) T/F LV O/C Relay Current for LV Bus Fault =    Amp.

9b) T/F HV O/C Relay Current for LV Bus Fault =    Amp.

10a) T/F LV Side O/C Relay Current as Multiple of PSM =   

10b) T/F HV Side O/C Relay Current as Multiple of PSM =   

11a) T/F LV Side O/C Relay Operation Time with TMS=1 =    Sec.

11b) T/F LV Side O/C Relay Operation Time with TMS=1 =    Sec.

12a) T/F LV Side O/C Relay TMS =    

12b) T/F HV Side O/C Relay TMS =    

13a) T/F LV Side O/C Highset Current Setting =    Amp.

13b) T/F LV Side O/C Highset Delay Setting in miliseconds =    ms

14a) T/F HV Side O/C Highset Current Setting =    Amp.

14b T/F HV Side O/C Highset Delay Setting in miliseconds =    ms

Topic SETOCTF Ex-4 Your score is:
Select Zone:
Select Unit:
Code Number:

1 comment:

  1. IN question no.8 HV side PSM is 27.25 as per its HV full load current but it is showing wrong answer need to be corrected

    ReplyDelete